Know-Legal Web Search

Search results

1. Results From The WOW.Com Content Network

2. National Electrical Code - Wikipedia

   en.wikipedia.org/wiki/National_Electrical_Code

   The National Electrical Code ( NEC ), or NFPA 70, is a regionally adoptable standard for the safe installation of electrical wiring and equipment in the United States. It is part of the National Fire Code series published by the National Fire Protection Association (NFPA), a private trade association. [ 1]

3. Circular mil - Wikipedia

   en.wikipedia.org/wiki/Circular_mil

   A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It corresponds to approximately 5.067 × 10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section. As the definition of the unit contains π, it is easy to calculate area ...

4. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   American Wire Gauge ( AWG) is a logarithmic stepped standardized wire gauge system used since 1857, predominantly in North America, for the diameters of round, solid, nonferrous, electrically conducting wire. Dimensions of the wires are given in ASTM standard B 258. [ 1] The cross-sectional area of each gauge is an important factor for ...

5. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking with ridged, grooves or white stripes on the surface of lamp cord.

6. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   NEMA L6 connectors are rated for a maximum of 250 volts. They are intended for two-pole, three wire, line-line-earth (or hot-hot-ground) circuits with a nominal supply voltage of 208 or 240 volts, depending on phase configuration. The L6 connector does not provide a neutral connection.

7. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   v. t. e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [ 1][ 2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via protective ...