Search results
Results From The WOW.Com Content Network
However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge shells with their lower pressure rating of 11,500 psi (79 MPa), began to approach the performance of the 3 + 1 ⁄ 2-inch (89 mm) 10-gauge shells with a ...
T scale, using 3 mm gauge track to represent standard gauge railways. 1:450. 0.677 mm. Model railways (T) T scale, using 3 mm gauge track to represent 3 ft 6 in ( 1,067 mm) gauge railways. Hasegawa also produces plastic ship models in this scale. 1:432.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Cellos exist in a smaller range of sizes than violins, with 4/4, 3/4, 1/2, 1/4, 1/8, and 1/10 being reasonably common. As with the violin, the Stradivarius scale is regarded as standard for orchestral work; This is about 27.4 inches (700 mm). Violas are commonly described in terms of their body length rather than by a fraction. There are two ...
The 37.5 mm length is not derived by a certain scale ratio. While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm ( 0.65 in) gauge from real life prototype 1,435 mm ( 4 ft 81⁄2 in) standard gauge standard gauge. Conversely, modeling standard gauge in Lego trains would yield a scaling of (37.5:1435 =) 1:38.3.
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length.
Fermière; cut lengthwise and then sliced to desired thickness 1 ⁄ 8 – 1 ⁄ 2 inch (3–10 mm) Rondelle; cylindrical vegetables cut to discs of desired thickness 1 ⁄ 8 – 1 ⁄ 2 inch (3–10 mm) Tourné; 2 inches (50 mm) long with seven faces usually with a bulge in the center portion; Mirepoix; 3 ⁄ 16 – 1 ⁄ 4 inch (5–7 mm)
Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.